Skip to main content

Reply to "Can't Set Accessory Voltage on CW-80"

A quick review of the procedure in case something was missed.

Turn throttle off.

Hold down all three bottoms - direction, whistle, bell.

Turn up throttle to desired voltage.

Release all three buttons.

Turn throttle off.

This procedure has always worked for me.  It’s surprising that you would have two CW-80’s that these steps wouldn’t work for.

Ron

That's the exact same steps I've performed on both.

Wonder what they mean by "raise the throttle slowly". I was taking 10 seconds. Too fast?

I'm slowly raising the throttle to 75 ( which should be about 14 volts).

Interesting that after trying several times, now the accessory terminals are outputting at less than 1 volts. Before I did this, they were outputting approx 8 volts.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×