Skip to main content

Reply to "Can two DCS "Powered" locomotives run in tandem using DCS Remote Commander?"

H1000 posted:
There is also a way to reset PS3 engines to factory without a TIU.

Only in some engines made starting in 2014, the firmware was updated to allow you to do a factory reset with the DCS-RC.

Here's the DCS-RC Factory Reset Procedure.

  • Turn off power if on Wait 15 seconds
  • Turn on power: the engine should be dark and quiet
  • Press SND
  • Press DIR
  • Press "-" (on the gray rocker in the center of the remote.)
  • The engine will give a two honk response and will be sitting on the track running The engine has now been factory reset, and is ready to run with your DCS Remote Commander system.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×