Skip to main content

cannot get dcs to add engine

I had two separate locos running then after shutting down the next time I tried to run either one I get engine not on track, or out of range , or check track.

these engines were running good before. I checked the voltage , 19v. I cleaned the track, the engine wheels and pickup. I even deleted the engines and tried to add them but no go. the TIU is powered by two bricks, one in the aux  one to fixed voltage in 2. the engine I am trying now is  30-4016E-1 . the tiu had a blown fuse that was replaced this engine has a BCR2 from J&W electronics

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×