Skip to main content

Reply to "Chuff Generator Install Help"

Truthfully, I'm at a loss.  I'm afraid I'd have to see how this is wired, I've never seen anything like that.  Are you SURE the chuff output from the C-G is connected to the proper place and any old chuff switch is disconnected?  Since the LED is blinking correctly, the sensor and chuff computation is obviously working.

It sounds like the port on the uP on the C-G has been cooked by injecting voltage into it, it wouldn't like that.

If you disconnect the chuff output and connect an LED and 100 ohm resistor in series between the chuff output andthe 5V on the C-G, do you see the chuff output pulsing in time with the on-board LED?

Attachments

Images (1)
  • mceclip0

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×