gunrunnerjohn posted:Does not compute, at least to me. When you program a TMCC device, be it a switch, engine, accessory, or whatever, it's a one-way conversation. You put the device in to programming mode and send the programming code. Only device(s) that are in program mode will respond. I can, if I like, program a whole bunch of devices to one TMCC ID, just turn the program switch on and set the ID.
I don't know what you're doing, but either the switches are broken or you're doing something wrong. Are you sure the switch is actually seeing the programming command?
It doesn't make sense to me either.
Sometimes the lantern will start blinking after pressing the black button and I then press "sw" and a number and then "set" - and the lantern does not stop blinking, so I presume it is not seeing the command. The only way to stop the blinking is to cut track power and when restored, the lantern is no longer blinking, but it is not programmed. Other times, the lantern will not blink at all after pressing the button, so it may be that some of the switches are defective.
