Skip to main content

Reply to "CNJ Heavy Mike project"

@GG1 4877 posted:

No question.  That is a Trainmaster side frame.  Your 3D printed versions are so much nicer than the cast ones.

The challenge with the truck block you are working with is that the center axle is offset from the centerline when the EMD A-1-A truck has equal axle spacing.



Thanks for helping to figure it out. At least I now have sideframes all around until I manage to come across a set of EMD A-1-A trucks I can swap them out. I look at the E8 as basically a throw-in with the Legacy Sharks, so as long as it runs, and isn't visibly missing any parts, it's good for now.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×