Skip to main content

Command programming lost

Need help understanding a problem with command programming lost on a Legacy controlled layout.

In a Lionel engine with ERR installed, the programming is lost about every other time I try to run it. I have to re-set the engine ID again. Then, yesterday when trying to run a Legacy E7 A-B-A train, I had a similar problem. The B unit was the only engine to respond to command start-up and run. The A unit on the head end had to be re-programmed. This is a Legacy command system on a layout with about 1200 feet of Atlas three rail track on two levels. Any suggestions would be appreciated.

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×