Skip to main content

Reply to "Common ground bus for Lionel command control"

Thank you for posting the question, Dale!  When our club member who is up on Legacy stated the wire from the Legacy base goes to the common rail, I questioned it in my mind.  I didn’t say anything since as you know, I’m an MTH guy too.  I just checked my TMCC base wire.  It is connected to the terminal block feeding the center rails.  The TMCC base is connected to the TIU with the appropriate cable.  I can run my two TMCC engines and One Legacy engine with the DCS remote fine.  It would seem to me we could use the common bus, but I also would like the Legacy folks to let us know.

Mike, thank you for clarifying common versus ground.  Yes, we mean common, and not tied to an earth ground.

Last edited by Mark Boyce

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×