Skip to main content

Computer Connection Problem

Greetings all,

 

I'm looking for a little guidance.  I'm attempting to upgrade my Legacy base and cab from v1.2 to v1.54 using my Dell laptop.  I've tried two different serial-to-usb converters (Trendnet and Tera Grand, both highly rated on Amazon).  When I plug the Legacy Y-cord into the Legacy base, the red light starts flashing slowly.  When I connect the USB converter to the Y-cord, both the yellow and red lights start flashing slowly. They continue to flash after disconnecting the converter.  If I attach the Y-cord to the computer via the USB end, the all of the Legacy base lights start flashing rapidly.  No matter what setting I use on the LSU software, the computer will not recognize the Legacy base.  After removing power from the base, and disconnecting the Y-cord the base will reset and just show a steady green light.

 

Any suggestions?

 

I'm anxious to run my Big Boy with full Legacy.

 

Thanks,

 

David

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×