Happy Monday!
Finished the back Mansard wall, the left wall with the other chimney and made a good start on the final little bit.
The top trim strip needed some gluing help in the upper right corner so I used med CA and of course it soaked through and made a bit of a mess. I will match the gray and paint it. I'll also add some minor weathering which will help blend the paint in. The shingles really trim up that ragged bottom edge. Hides a lot of ugly.
On the second chimney wall I tried changing the flashing method on the chimeny. I marked the wall's curve on the chimney's brick side and then applied the flashing with the chimney off the model. Again, I had to cut little fingers on the side of the flashing that needed to stretch around the curve. I had to apply the gel CA and install the chimney with the flashing attached in one go. I did this and then saw that I had cut the fingers on the right side flashing facing in the wrong direction. That wouldn't work! But it was too late to pull the chimney off and redo, so I just ripped off the bad flashing and did the right side the way I did on the other chimney, i.e., piece by piece.
I also realized I didn't have to put an entire strip of shingles behind the opened-back portion of the chimney since it was out of sight. Instead, I just put pieces on both sides just long enough to nestle behind the gap.
I got flashing on the last window and then started to put on its shingles when I ran out of time. I will finish up the Mansard roof tomorrow. I had to install the attic stair surround railing before I forget. I also have to attach one of the LED leads whose foil tore in all the handling.
See y'all tomorrow.