The head printed half good. The valve area printed decently, but the other end… the plain end, separated from the support web and didn't form properly. I'm going to keep experimenting with the orientation and maybe increase exposure timing just a tad.
The good: All the bolts are recognizable. The camshaft is completely separate from the deck below. Without a magnifying glass you really can't see some of it.
The bad: besides the right side deformation, the fuel rack levers are deformed and missing on the 3rd cylinder. The rack levers are missing and probably weren't on the drawing. I'll check it out. Head clamp bolts need to be taller to stand out more. I'll figure it all out.
