Skip to main content

Controlling DZ-2500C switch machines at a panel with a momentary push button and a red and green LED

This is the schematic from a 2016 post that it says came from Dennis Zander. So it must be legit. 

However when I hook this up using a red and green 3mm LED (with a resistor) on pressing the Momentary PB the DZ-2500 does flip between the two turnout positions (nice) but the 3mm LEDs are both lit although one is stronger.

What am I doing wrong should not in either position the opposite LED be off not on???

Note that the white wire shown in the diagram coming from the DZ-2500C IS connected to one side of the PB even though it doesn't sort of show that. And the DZ-2500C's green and yellow wires are connected to one of the red(+) sides of one LEDs; the black(-) LED wire is connected to COM.

 

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×