Reply to "Controlling DZ-2500C switch machines at a panel with a momentary push button and a red and green LED"

Yes I will. The circuit uses two MOSFETs (whatever that is ) to switch power to the LEDs.

DZ-2502 controller circuit

 press the H (high) to change to L (low) that simulates what the DZ-2500C sends back to the controller to trigger the LEDs; Both LEDS shown are RED for on. Two are shown so that one remains on the breakout board for testing. Moving your mouse around will show the current and voltage at the various components. The momentary switch is not shown but that  just grounds the circuit to the White wire on the DZ-2500C

My laser cut control panels as well. Because it's cut by a laser cutter and not an Xacto knife I can make the track lines as inlays in another color of Plexiglas and perfectly inlay the track lines into the panel.

All holes for LEDs and momentary switches are not drilled but again perfectly laser cut too.

Last edited by AlanRail
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×