Skip to main content

Reply to "Controlling MTH PS3 trains in conventional mode after assigning to DCS"

The TIU light going out is an issue and indicating a problem inside the TIU.  If your powering via Fixed one do you have voltage out when TIU LED goes out after blink?  Once that is out, remote and engine can no longer receive commands.

There are two separate memory in PS-3 that do not fully go to factory reset when doing a DCS Factory reset.  Hence the need for conventional reset.  Even back in PS-2 day, were were advised to do a DCS reset, then follow up with a factory reset conventional.  Then ship to customer.

I see this occasionally were engine works in DCS, but I have to do a conventional reset to get it moving in conventional.  The run away trains have been a rare occurrence, that I have not see this past year?  So not sure if it was a software bug, worked out in current flash codes.  G

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×