Skip to main content

Reply to "Conventional, LionChief & MTH DCS Remote Commander Question"

EddieZ posted:

As you can see, I have a mix of trains.  I was wondering, if I have a single loop with sidings can I run a conventional set and a controlled set on the same (loop) layout.   This is what I envision.  MTH or LionChief on siding, not moving, Conventional in neutral on second siding.  Start conventional adjusting speed by transformer, then park conventional back on siding in neutral and start up MTH or LionChief.  

Thanks,

EddieZ

how much voltage will the conventional have been running at? because the lionchief needs between 15 and 18 volts to run good.

the mth you did not state what it is, conventional or command.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×