Skip to main content

Reply to "Convert my MTH Dash-8 to DCC"

Well, since you don't have the switch, you'll have to pop the top.  There should be a loop of black wire between two contacts at one end of the  40-pin connector, those are the switch wires.  In many of them, the loop is long enough to cut, install the switch, and have it switchable.  If you want just DCC all the time, just cut and insulate the ends of the wires, Job done.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×