Skip to main content

Reply to "Cruise Commander M FULL SPEED ONLY?"

Hmm, interesting enough I have the exact same engine.  Did the Cruise Commander M upgrade as provided.  Double checked the serial data was properly connected before powering up.  Then went through normal programming even though I didn't change the radio board.  And I got the same response...engine took off at first step.  Double checked everything...all good.  Put the old commander back in to make sure everything else was good.  The engine performed properly.  Reconnected the new cruise M.

Then, went back to Gunrunner John's suggestion about disconnecting the IR transmitter.  Now the motor/engine responds properly!  Looks like I get to build a simple buffer/amp as suggested.  The 2n2222 is a fairly generic transistor.  I have lots of the 2N3904 and should work just as well.  Thanks for the suggestion!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×