Skip to main content

Reply to "CSM2"

You have to give the CSM2 an address first. Push the program button on the CSM2 and give it a switch ID. Then the First DZ2500 (the one that goes in switch sense terminal 1) gets the SAME ID as the CSM2. Proceed up sequentially in numbers from there. Theres an example in the manual.

I set one up last week and had absolutely no issues getting it to take any addresses. I did not use the breakout boards. It may have even been easier than doing it with a 2001 on a SER2. 

 

Last edited by Boilermaker1

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×