Don't know if I asked this question before but here goes. My "under construction" layout will be using GarGraves track with Ross switches. I'm using O-54 for my outer loop, and O-42 for my inner loop. GarGraves curves come in 45-degree segments for those two radii, but for the Ross switches, the O-42 is only 32 degrees, and the O-54 is only 30 degrees. Do I have to cut a corresponding radii track section to make up the difference, or does Ross make a special track section that I'm not aware of? If I cut the track, I'm assuming that the procedure would be to lay a curve section on the switch and mark where the switch ends. Any help is greatly appreciated.
Original Post