@MattR posted:That's great. Making that with some inexpensive accessories that a lot of us have extras of. I should send you a couple of my spares and have you make one. As simple as it may be I WILL screw up cutting that roof
Once you remove the base.. get a plain sheet of reg 8x10" paper and on the left and right side of the 445 building use your pen and scribe the ends .. then cut it , Once you cut you'll have the 8" x plus width of the building to put on the roof..
What i do is fold that paper in half long ways and use tape to mount it on the roof make sure you tape it good.
Then I use a pocket ruler (the 6-8 inch steel type) and center the bottom of the 445 (just mark it on the bottom where center is)
then use your ruler and put it flush on the frount and back of the building . and mark it on the paper you taped on the building..
Use a razor saw and common sense. and slowly cut it take your time on the lines you made on that paper
what I do is use a razor blade (or you could sand it flush )and remove the step guide rail and any part that is not flush on the side where the steps where
use the bottom window for the area the outside shed was cut a hole and super glue it on with the window shade... wire it up and enjoy .!
daniel