Skip to main content

DCC decoder install using older Open Frame Motor

I have a old Max Gray Loco which uses an open frame motor. I use DCC for control and usually deal with can motors. However for this install I'd like to try using the original Open frame motor. I insulated the motor from the frame using nylon fasteners. But the motor shaft which goes into the metal gearbox obviously overrides my effort causing the frame and motor to become shorted. Not sure how to approach this issue. Your thoughts appreciated.

Thank you

Bob

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×