Skip to main content

DCS Explorer update

I just picked up a DCS Explorer and love it but while it operates my Protosound 2.0 locomotives just fine, it will not operate my Protosound 3.0 locomotive. The PS 3 locomotives PS 3.0 was installed by an authorized MTH tech a couple of years ago. Has anyone hear had a similar experience, do I possibly need to update the firmware in the Explorer? Any help would be appreciated.

Update

I know this post is a little old but I am a lot slow at figuring things out. This problem was driving me nuts until I for soe reason decided to check and see if there was a switch on the bottom of the locomotive. Well there was and apparently this switch moves it from DCS operation to conventional only operation. A flick of the switch and the problem was solved. No if I can just get down programming the PS 3 locos it will be great.

 

Last edited by RRAddict
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×