Skip to main content

Reply to "DCS Setup Help"

Originally Posted by jlm1973:

I'm getting things figured out.  Tonight I opened up the remote and reset the rf board, now the remote works.  I also ran a check on the signal and it is between 3 and 5, this is on the 40" test track and the layout.  Tomorrow i'll make some good wire leads with good crimped on connectors and rewire the TIU, track and transformer connections.  Also Barry's book showed up today and just skimming through it I'be learn a few things to try. I feel like I see light at the end of the tunnel.

 

Again thanks for everyone's help.

 

James

A dcs  track signal between 3 &5 on a 40 inch piece of track is not a  good thing.

 

It could be a dirty track ,engine pickups.  or a faulty TIU... Take a look on the bottom of the tiu. There was a bad batch of tiu around 2008 that put out a low dcs signal... If your Tiu is I3A it could be one of them. .  Hope not.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×