Skip to main content

Reply to "DCS Signal and Layout Common Ground Question"

Originally Posted by Barry Broskowitz:

Tom,

 

My mistake. Just substitute "Z1000" for "Z4000" and the mistake that you made is the same. Just reverse the Z1000's 14 volt output into your TIU's Aux. Power port.

Sorry, but no mistake was made.  The real issue was the two outputs (18V fixed and 14v fixed) from the Z1000 brick were not in phase - only the 14v was in phase with the Z4000.  When I tried to use the 14V for accessories and the 18V for TIU aux pwr, the problem occurred. 

 

Internal wiring of the Z1000 brick was the issue.  Others need to beware - that is the primary reason for continuing to belabor the point.

 

Tom

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×