Skip to main content

Reply to "DCS spur question"

walt rapp posted:

I haven't read a lot in this thread so pardon me if this has been mentioned. 

I'll assume you only have one power source.

To me, this is an easier, and FREE, option.  Since you talked about using Fixed 1, obviously you're using DCS and have a TIU.  You could run 2 wires from the input (+ and -) of the FIXED 1 to the input posts of either of the VAR channels keeping it set as VARIABLE (versus changing them to fixed output).  Then run wires from the VAR output to the spur.

Then when you want to power the spur, just turn up the voltage on the VAR channel.  It would act as such as an on/off toggle or switch.

- walt

I like this idea...will give it a go....thanks

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×