Skip to main content

Reply to "De-Railing going into and out of .022 switches"

@Jim R. posted:

I assume you haven’t created S curves surrounding your 022 switches. Picture might help.

I'm a little hazy on whether I positioned these 2 switches incorrectly.  Two "legs" of each one DO immediately go into an 031 curved tubular section of track, and all three "legs' of the other switch go directly into 031 curved sections.  Could THIS be causing the peculiar de railing, and the "sensitivity" of electro coupler's arms?

This is really frustrating- even my HEAVY vintage Lionel Automatic Dump Car #3469 sometimes de rails halfway over the switch. Of course if I CRAWL I can avoid it, but I wouldn't think this should be necessary. I've attached some pix, including a PROPOSED shot of where I USED to have the switches- an unconventional side by side arranResized- End of table showing current problematic 022 switch and SW8 EngineResized- PROPOSED old design DSCN0588Resized- Showing BOTH of the problem switches currentlygement, eliminating ANY direct curves to any leg of the switches using 5" straight pieces of track.

Attachments

Images (3)
  • Resized- End of table showing current problematic 022 switch and SW8 Engine
  • Resized- PROPOSED old design DSCN0588
  • Resized- Showing BOTH of the problem switches currently

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×