Skip to main content

deisel premier 20-20327-1 ps 3/2 board dcs wont work only conventional beleive board bad?att GGG Bruce, John

I was sent this engine for repair sometime it would start up dcs and then  just shut itself off. sometimes he let it sit over night and then it might start! today I looked it over and found a pinched blk wire near the speaker for dcs or dcc switch . I suspect the blk wire that hooks to the dcc switch is the one wire that grounded out to the frame. I believe this was pinched at the factory when the train was build!
so my question is due any asc tech's think that would have damaged the board it will run on conventional but not on dcs I had deleted engine and then tried recover command could not get engine to add to dcs again believe board now is total issue. any ideas?
Alan
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×