Skip to main content

Reply to "Design of a $10-20 DCS-TIU Port Tester Tool?"

And from the peanut-gallery, if the Gerbers are still pending, how about a hole to make a strain-relief loop for the battery holder wires.  I'm not clear if you're advocating the 2-pin male-female connector (looks non-polarized which is iffy IMO) as the on-off mechanism.  But if running the red-black battery connector wires soldered right to the pads (no connectors), looping the wires thru a hole is a cheap "free" strain-relief to prevent the wires from breaking at the solder joints.

peanut gallery pot shot 1

Attachments

Images (1)
  • peanut gallery pot shot 1

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×