Skip to main content

Reply to "Design of a $10-20 DCS-TIU Port Tester Tool?"

gunrunnerjohn posted:

Here's the latest build.  I updated the previous post with all the build files, link below.  This adds Stan's power switch and the 1ma power indicator, it's the blue LED.  I also shrunk the LED's to 3mm LED's no reason to make them king sized for such a small board.

I think we have reached critical mass, if I want to put more on it, I suspect it's time to to to 1/8W resistors.

TIU Signal Tester Rev. 1.1 3D View

Link to post with current build files: TIU Signal Tester Rev. 1.1 Build Files

I think I know where the post is with the latest design files, but I could also have lost my way?   Now the 'New Linky No Worky' at least not for me.    However, if the link goes to the last post with an upgrade, which I think it does, I think I got it!  

You guys go way too fast for me, by the time I partially figure out the latest changes you are at least a board design or two ahead of me.

Any chance you guys could type a bit slower... 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×