Skip to main content

Reply to "DIY layout walk through access - Turkey Lift table complete"

I use a 3 1/2" hole saw with a 1/4" pilot on a drill press stand  to cut out the plywood disks.  The plastic/vinyl nipple pad is cut with the same hole saw with a hand held drill motor on some scrap Homasote.

I use a vac on the drill stand to keep the circular cut clean.

IMG_8679

You can see the 3  1/2" scars from cutting the disks on the scrap 2 X 12.

I then insert a large landscape timber nail into the pilot hole and hold the disk  with friction on a router table with a 1/4" round over bit. The disk rartles around somewhat and is a tad nasty but it gets the job done.

Attachments

Images (1)
  • IMG_8679
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×