Skip to main content

Reply to "Does anybody know the steps for programming a Cab1 engine using the newer Legacy remote control?"

Thank you everybody for the answers.  I'm such a goof and I humbly apologize.  But, I thought I'd let you know this scenario.   After I had programmed the NYC Hudson with the Cab1, the NYC 5444 Hudson was accepting commands.  So, I kept attempting to program repeatedly with Legacy, but to no avail.  Then the Hudson started to act screwy.  I thought I'd check the 9 volt battery in the tender and voila....the battery had enough juice for the Cab1 to be recognized, but not the Legacy.  After testing the battery and replacing the battery, the ol' NYC 6-28072 was able to receive the commands from the Legacy remote.  I thought I'd let you know in case somebody else might have this happen.  It's enough to cause you to start to drink :-)

Last edited by trainmanmason

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×