Skip to main content

Reply to "Does anybody know the steps for programming a Cab1 engine using the newer Legacy remote control?"

OK but back to basics:

When you enter programming mode on the engine (changing the program/run switch to program) and then power it, pay attention to the headlight of engine, does it blink when hitting the set button on the CAB2 ensuring the CAB2 is also in TMCC or CAB1 mode for that ID?

Again, the idea is you are knowingly sending a TMCC formatted command (not a Legacy command which it cannot understand) to the engine while the engine is in program mode, an indicator that the engine received the command is the momentary blink of the headlight.

I never paid any attention to the headlight, I just expected it to blow the whistle after hitting set.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×