Skip to main content

Reply to "Dull cote issues"

I've never had much luck using Dulcote from a rattle can. Lots of time it leaves a mottled finish although every once and a while it comes out good. Like others said humidity has a bad effect on it but I think the main problem is in the nozzle. The spray droplets are too large using the cheap nozzle. I always use an airbrush with Dulcote. Thin it about 25% first, use an external mix airbrush at about 30 pounds pressure. This results in a very fine spray so it goes on evenly and dead flat.

Ken

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×