quote:Reply
Soo, i read all the threads above. I didnt see the part about only having a legacy base. Is this true? you dont have a cab-1 base connected to the Legacy?
If you only have Legacy base only then i cant offer any advice because i dont know this patch etc.. needed.
I know the frustration you feel, i went through alot when i first bought them. But reading the Instructions all the way to the end twice really helps.
When in programming the lights go back and fourth fast, this is when you cut the power to them to get them into TMCC mode, THEN you can assign them IDs the second time you put them into program mode. the instructions also tell you when you first power them up there is a certain blink for Tmcc and a blink for DCS, you can identify the mode by this initial blink.
After that they cant be anymore simple. 3 wires for the switch motors. The only thing that is NOT explained in the instructions is that the Data drivr Ground and the Switch motor Ground Must come from the same Transformer and share the ground.I use 14 volt for the data driver 17-18 for motors.
