I just bought a new old stock railking steam engine w/ps 2. I’m able to add it in dcs remote without issue. It’s runs, smokes, and sounds just fine. However after I shut down and try to run it again later, the remote can’t find the loco and I get the error message ‘engine not on track’. I’ve tried deleting the engine, then re-adding it, and it works again...until I shut down... then it’s gone again. I’ve tried resetting the engine to factory, and again it works fine until I shut down. This is the only engine I own that does this. Very frustrating. Is it a fault with the engine? What can I do different? Thanks.
Original Post