Hi all,
I finally took time today to pin down the behavior on the NWTL. In short, it appears that Super Mode is not functioning when moving engines out of the inactive list on V4.20.
Here's what happens. Add an engine on a given TIU (any address, but let's say #2). Move it to a TIU with a different address (let's say #3). Put both TIU's into Super Mode (if they're not already). You will have no problem operating the engine on TIU #3. Now put the engine into inactive. You will not be able to recall the engine to the active list until it is back on the TIU with which it is associated (TIU #2). If you perform a Read it will be properly re-associated with TIU #3. Once associated with TIU #3 the engine will move in and out of inactive without trouble. Put the engine back on TIU #2 and it will not move out of inactive.
The behavior remains the same when the remote is in either Normal or Speed operating modes. It does not matter whether the remote has the TIU's set for Super Mode when the engines are added to the remote.
I hope others will confirm or debunk the results of these tests and post about it here.
|
|
