Skip to main content

Reply to "EOB upgrade?"

@JackO posted:

Pardon the thread interruption... What's EOB?

EOB was Train America Studio, Mike Reagan, Youngstown, Ohio, at the time.   A speed control, drive board, that was motor flywheel tach-strip oriented.  There were upgrade kits available, and some relatively good install instructions, for do-it-yourself.  Down-side acceleration/deceleration was not linear, more of a parabolic curve type of acceleration. There was also a high pitched whine, that for some was a concern.  Back on the positive side, mother boards had pretty good circuit design, with a full 8 amp capacity.  IMO,  Mike CT.   Installed in a set of Weaver E8's that I have.  At one time the SAW group, Sunset, Atlas, and Weaver, used these drive boards.   Link to EOB install instruction from this forum, complete with the many different adjustments.  Click on the underlined phrase,  Cab1 remote, TMCC command base adjustments.   ?? page 27 to the end of the document??

Last edited by Mike CT

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×