Skip to main content

ERR AC-DC in an IC 6006 SD40 keeps stopping...

If I run it conventional, no problem. But on CAB 1, it runs a half loop and quits. Press the "R" (key #8) and it resets so I can run it again...til it stops. When it is stopped, no movement, but all sounds work. Reset and go again. I exchanged the R2LC board module, no change. I put ceramics on the motor brushes in addition to the 1uF caps, no change. Wiring looks ok of course. Just wondered if anyone has had experience with an ERR AC-DC where this happened and they found some cause that I could look into besides replacing the ERR motor drive board.

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×