Skip to main content

Reply to "ERR Cruise Commander M and a Lionel TMCC N&W J 611, Installation Issues"

Yes.

Mother board feeds the regulator as it normally does. Remove the ground (pin 10), add in the 4th wire from motherboard to cruise m, remove second pin (pink) from 4 pin on cruise m. The second slot in the 4 pin on the cruise m must be open. If you let the mother board and the cruise m feed the regulator it will not operate correctly. Mine would run and shut down after a while. Let it sit and it would start working again for a few minutes. Pulled the pink wire and it’s been fine since. 

Last edited by SPFord27

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×