@Tranquil Hollow RR posted:That is a great looking outcome Bob. As with your other endeavors; impressive!
Thank you Jay. I'm having fun with this project. Hopefully the outcome will be as satisfying.
A quick update- I needed some smaller diameter heat shrink than what I had on hand. I went by our local Micro Center yesterday, (about the closest thing to Radio Shack today). They have a decent Maker and STEM area that is relatively well stocked. First I picked up a nice assortment set, a little pricey at $20. I also grabbed some 220 ohm resistors, and some short jumper wires that fit on the pins for the couplers on ERR boards.
Then I thought about getting a heat gun for the heat shrink. I usually use a lighter to shrink tubing but when working near other components, that can be a little dicey. I found one for $25 and then saw another with the same set of tubes I had in hand with a gun for $30.00. A win all around. A couple of new tips for my soldering iron came along for the ride too.
I also tried making a wiring harness. Need to fine tune it a bit but this will work.
Bob