Skip to main content

ES 44ac American flyer not responding

I have a ES44ac American flyer that is no longer responding to any commands from Legacy controller.

It was running fine and I shut the power down on the layout, I did not shut down the engine first (there where 4 other engine on the layout when I did this) however was stationary at the time standing still. 10 min later I  powered up the layout again, the unit seemed to power on and and you could hear the engine rpm's rise and just stays that way, it does not respond to the legacy controller.



I have tried to reprogram the engine but it does not respond, it seemed to be stuck in some mode. if I try to open the couplers it does open them so it is getting some signal.

is there a master reset the returns the engine to as purchased? any help would be appreciated.

this was posted in the s gauge forum but it was recommended to  post it on this forum.

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×