Well I discovered another O60 switch with the same issues. Since I am waiting for a replacement on the 1st switch I took matters in my own hands. 1st i swapped out the 2 center plugs on the mother board with each other. That fixed the lantern light and the hand switch. Green in the right direction as was the red. However then the switch motor would not work. Could only switch manually. Here is the photos of the plugs that I swapped on the motherboard.
So to fix the switch motor I figured the yellow wire and the red wire connected to the motor had to be backwards. So I unsodered the two wires and swapped them out. Reassemble the motor and cover plate, hooked the switch back into the layout and wallah. It works as it should. Here is a pic of the wires to the motor before being swapped.
So if you have any switch issues like I had it was not overly a difficult fix, I did improve my solder skills. If you have any questions contact me and I will try my best to help. Nick.
The last pic is Lola's surprise look after I shouted gratitude for a correct operating switch.