I had to do this to two of my older Fastrack switches, so I know what you mean. There is a little "bump" right before the rail that is supposed to help guide the wheels past that junction, but apparently the switch rail sometimes has too much bend.
Nice video, makes it clear what you have to do. I would mention that you don't want to put excessive force on the rail laterally as it's mounted in a plastic carrier and if you break it, you have a big problem.
Good point! You must be very careful and be gentle as you are bending the rail. Just a very little bend. The metal on those rails is actually pretty soft and you could break off the tip if too aggressive. Sometimes I think people would just know that but I forget not everyone thinks the same way.
Thanks for pointing that out.
