Moonman
I looked at the 50-1014 and saw what you are talking about. Locations 1-12 have, for ease of terminology in my case, a red screw and a black screw. At the bottom there is a very large red screw on one side and a very large black screw on the other side. That's where you attach the board to the TIU Fixed Out port. Am I correct?
Also, I am going to change how I set up the Base 1L wire from the U connection. I just need to make sure I am on the right page with this. I can run the Base 1L wire from the U connection on the box to the black wire leading into the Fixed In or out port. I assume based on how it is hooked up now, it would be the out port wire since that is the wire leading to the same track that I just unhooked from. However, if I attach the TIU to a terminal block, would I run that wire to the ground screw on the block or can I run it to the ground wire connection at the out port. So long as this wire is connected to the ground wire leading to the track in whatever way it leads there?
I know, a lot to swallow. Hopefully I haven't frustrated you too much. You are helping me in ways that I can never repay. If I haven't said thank you enough, please know I do appreciate your time and patience. This forum is about all I have to go on when it comes to train tech support. I don't know if the rest of the forum has the same ignore me issues that I do with actual train stores, but for all the help they are when you can get a person to answer you or talk to you, they are very bad about answering emails, and I leave more messages than I get voices on the other end of the phone.
John
