After a second coat, and expedited drying thanks to a heat gun, I was very satisfied with the one swipe from the block with 1000 grit. On to wet sanding the area to clean up the horrible pebbling left by the yucky rattle can primer….now you can see the repair area is slick, but scuffed, at this point, the repair area is actually ready for top coat, ….but let’s look at the surrounding edges carefully!…blow this pic up,…look at the edges not cleaned up by wet sanding yet!…that pebbling, if left alone, will cause your top coat to ramp up in that area, and cause bunching of the top coat,…so you have to look at every square inch or in this case, every square mm to insure a slick, but scuffed finish,….I’ll finish blending this red into the black, and then we’ll prep for top coat….In the second pic, you can see in the angle of the picture how the shape is perfect ….
Pat 
