Next steps in the quest for a better finish.
OK this is what things look like after I worked a lower area that was a little high and the edge near the generator bracket.
the two areas being pointed to are low, the first picture not too bad, but the second with the old putty is more noticeable. Not sure I want more epoxy though, as I afraid of too much. The bright spot is metal.
Here is the area ready for filler primer. I forgot to wipe it down. 99% isopropyl alcohol? Wet sand first before primer of not?
I know primer needs to sanded to start feathering in, that' s an always. Wet with 1000 grit or finer?