Rickw2 posted:Gregr how would one set up a Powermaster (or TPC400 in my case) within the app? The only thing I can think of is connecting fixed output of TIU into TCP400 then to track and use Cab1 or 2 for conventional. Would DCS pass through that?
I HAVE noticed that on PS1 locos the sound is very choppy on startup not to mention the 5.0v minimum.
Essentially, you would follow the directions in Barry's book to connect your TMCC base to the TIU with the appropriate cabling. Then you can address the Powermaster through the MTH DCS app just like you would an engine. On my layout, TMCC ID#1 is my Legacy Powermaster. So, I set up the Powermaster as an engine with ID#1, and then use the speed dial on the app to adjust the voltage. Horn/whistle and bell buttons also work in conventional too.
I am surprised you experience choppiness with your DC motored PS1 engine. Usually, the electronics on DC powered conventional locos smooth out the dirty power. On AC motored equipment with traditional E-units, the TIU's coarse chopped wave variable AC results in a jack-hammer effect on motors and reversing units.
