Skip to main content

Reply to "Fuses on a DCS System"

Lioneljeff posted:

OK, got it!!  The power brick will be wired to the AUX ports.  The KW will be wired to Fixed In #1.  I seen a section on DCS Companion on how to phase the transformers, so I will do that.  So, only one power brick is used, correct? 

Yes that should work out nicely,   I like this better.

 

KW for fixed 1 (20 volt posts) U & D I think but not really sure) with  10 amp fast blow fuse between  KW and fixed 1 in red.

However you may want to use a KW  handle if  want to run conventional as well on fixed 1.

Z-4000 for var 1&2  set to var mode.

 the brick for the tiu aux power supply.   Good luck and have fun.

 

Last edited by Gregg

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×