Skip to main content

Reply to "Gaps at joints in Gargraves track"

I just use a small hammer and tap the pin(s) into the end of the rail(s) slightly past the tiny hump at the center point. Two sections of track then join tightly...or tightly enough so a significant gap is not evident. And, no, it does not distort the end of the rail (in case that question comes up).

Last edited by Allan Miller

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×