To add to Gunrunner John, one other good thing about JB Weld is that it's a dark grey color, so it'll blend in a little on the grey steps if you get a tiny bit showing. Although, as John says, just use a tiny bit so it doesn't show. Regarding the visor, I've had bent visors quite a few times. These are attached to the side of the cab with a couple of metal rods, and you can bend the visor back up into a better position that matches the one on the other side. You can tell yours is bent down from the gap between the inside of the visor and the cab. Use two thumbs to equally bend the front and rear of the visor at the same time (in your case, you'll want to bend the visor up). Just bend it very gently, and very slowly, to reduce the chance of loosening the rods that stick into the plastic on the side of the cab. (Experience talking here. 
)
|
|
